Saw blade is a general term of a sheet circular cutter for cutting a solid material.The following instructions refer to diamond saw blades installation requirements for stone cutting.

1.The equipment is in good condition, the main shaft is free of deformation, no jump, the installation is firm, no vibration, etc.

2.Check that diamond saw blade is damaged, tooth profile is complete, saw plate is smooth and clean, and there are other anomalies to ensure safe use.

3.When assembling, make sure the direction of the saw blade arrow is consistent with the rotation direction of the main shaft of the equipment.

4.When the saw blade is installed, it is necessary to keep the shaft, chuck and flange clean, the inner diameter of the flange is consistent with the inner diameter of the saw blade, ensure that the flange and saw blade are closely combined, install the positioning pin and tighten the nut. The size of the flange should be appropriate, and the outer diameter should not be less than 1/3 of the diameter of the saw blade.

5.Before the equipment starts, under the condition that it has been ensured to be safe,there is a single-person operation device, jog idle, and check whether the steering of the equipment is correct,check for vibration, diamond saw blade installed and idling for a few minutes, no skidding, swinging or beating to work normally.